RUMLOGNG FLEX HOW TO
RUMLOGNG FLEX INSTALL
RUMLOGNG FLEX DRIVER

The Contest Band Map and the option Menu–>Contest–>QSOs to Band Map in S&P must be active. In contest and in S&P mode found stations can be displayed as well. /rebates/&252frumlogng. If you log a new QSO, the data af other affected shown spots (new multiplier, new DXCC, …) will not be changed. Getting WSJT-X running on a Mac takes a few extra steps. I have a previous post on this, Icom 7300 WSJT-X Using DXLab Suite Commander, JT Bridge And RUMLogNG.

RUMLOGNG FLEX INSTALL

Spots with a lower priority will be dropped. Before using this you’ll have to install WSJT-X. FlexRadio only: The Priority parameter is used when the space becomes limited on the screen. You can use one source only at a given time. Basic logging features are included for the higher bands up to 1.2 cm and. When setup as part of a macro in Fldigi, the script will automatically take the current QSO and will log it to the current RUMlogNG logbook Once the initial setup process has finished, you need to set the parameters of the signal from your tracker I have struggled with Fldigi setup for about a week 01 KB) This web page is about Fldigi 3 Its. See Menu–>Transceiver–>Spot to Flex or Spot to SunSDR Information from the active logbook or from the open contest can be used. RUMlogNG is a HAM radio logging, QSL handling and printing tool, especially made for the short wave DXer, made by a DXer. RUMlog can send colour coded dx-spots to the SDR software or direct to the radio. The build in CW keyer is supported for both types of devices.Ĭurrently RUMlog doesn’t work correct with Multiflex! DX-Spots I recommend you leave the prompts on Ive been through all this stuff Setup your 7300 as described in this post Icom IC-7300 Digital Mode Settings Command line. You still need an application to operate your SDR.

RUMLOGNG FLEX HOW TO

I think if I have RUMlogNG control the Slices, I don't need xCAT but I haven't figured out yet how to make RUMlogNG work with two slices (although I think it should since it will control two rigs).

Interface: tcp/ip For the tcp/ip address you have to enter the data from the FlexRadio transceiver! With use of the Discover button, you can search for a FlexRadio in your network and you can use the address data for the first found device. I am currently using RUMlogNG but I've not yet figured out how to have it control both slices. Interface: Web Socket For the tcp/ip address you have to enter the data from the ExpertSDR Software! FlexRadio Mike (NF4L) has taken the time to put together a small guide to help others in setting up this script and making it work with both Fldigi and RUMlogNG This document will show installation, setup, and basic use of Fldigi, Flmsg, and Flwrap Verify all boxes are checked Download fldigi-4 Enter the information into the form Enter the information. You have to use the following settings in the TRX preferences: SunSDR

RUMLOGNG FLEX DRIVER

These connections are established over the network, not via cable. net/projects/fldigi/files/ Look for IC-7100 > USB Driver Utility Read the USB Driver Installation Guide I really do recommend reading the installation instructions. Similar to a ‘classic’ transceiver, RUMlog can be connected to an SDR trx for CAT control.

Rumlogng flex